• Showing 6 of 6
• Sort By  Name A - Z Name Z - A Price Lowest to Highest Price Highest to Lowest View All

General Purpose Blade Tool
General Purpose Diamond Blade Tool. 20x30x5mm thick containing 5 layers of interlocking long diamonds

Our Price

£36.95 GBP

Qty:  

Precision Adjustable Blade Tool
Precision Adjustable Blade Tool, 20x32x5mm thick, containing handset natural diamond grit

Our Price

£43.07 GBP

Qty:  

Precision Adjustable Blade Tool
Precision Adjustable Blade Tool, 10x28x5mm thick, containing 5 layers of selected needle diamonds

Our Price

£47.52 GBP

Qty:  

Tool Holder
Tool Holder for General Purpose Diamond Blade Tool. 20x30x5mm

Our Price

£8.95 GBP

Qty:  

Tool Holder
Tool Holder for Precision Adjustable Blade Tool, 20x32x5mm

Our Price

£8.95 GBP

Qty:  

Tool Holder
Tool Holder for Precision Adjustable Blade Tool, 10x28x5mm

Our Price

£8.95 GBP

Qty:  

Tips - Maintaining your Diamond Dressing Tools

• Results of Neglect - you may recognise these signs.
• Chatter or gouge marks - Diamond broken or chipped.
• Diamond lines on work - Increased diamond wear or broken diamond.
• Chatter marks on work - Diamond is dull and is crushing rather than dressing the wheel.
• Reduced diamond life due to burning - poor flow of coolant on diamond whilst dressing.
  
  Maintain sharp diamonds 
• A dull diamond tends to crush the grains into the bond of abrasive wheels and crack them without giving a clean break.
• Grains of wheels that have been crushed in this manner will give the effect of wheel loading - cracked grains will also come out whilst grinding and produce scratch marks in work.
• Some precautions when setting up a diamond tool
• Be sure diamond holder is securely held with minimum overhang.
• Be sure diamond is not cracked, burned or flatted.
• Be sure, whilst dressing, the diamond is not subjected to excessive shocks or bumps.
• For best grinding finishes be sure diamond cutting angle is not too sharp.
• Be sure, whilst dressing, the contact point of the diamond receives plenty of coolant. 
• Whilst dressing, diamond cuts should not exceed 0.001" per pass.